Subaru Forester: Setting the clock manually / Type A multi-function display (black and white)
- Turn the ignition switch to “ON”.

- Press the
button.
- Select “Settings”.
- Select “Vehicle”.
- Select “Time/Date” and then select “Manual”.

- Press the “+” button or the “−” button
beside the clock.
Setting 12-hour or 24-hour display
The clock can be set to 12-hour or 24-hour
display. Perform the following procedure to
switch the display format.
- Turn the ignition switch in the “LOCK”/
“OFF” position.
- Press and hold the “−” button located
near the clock display for approximately 5
seconds. The clock display will then start
to flash.
- While the clock display is flashing,
press and hold the “+” button for approximately
2 seconds. The clock format will
then change.
- The clock display will continue to flash
for approximately 3 seconds to indicate
that the clock display has been changed.
Turn the ignition switch to “ON”.
Press the button.
Select “Settings”.
Select “Vehicle”.
Select “Time/Date” and then select “Manual”...
Other information:
This information indicates the relative
performance of passenger car
tires in the area of treadwear,
traction, and temperature resistance.
This is to aid the consumer
in making an informed choice in the
purchase of tires.
Quality grades can be found where
applicable on the tire sidewall between
tread shoulder and maximum
section width...
Total time in conjunction with the trip
meter
Total time in conjunction with the ignition
switch
This display shows the total time that the
engine was stopped by the Auto Start Stop
system in the following ways.
Total time in conjunction with the trip
meter: Displays the total time that the
engine was stopped by the Auto Start Stop
system, from the last time the currently
displayed trip meter was reset until the
current time...