Subaru Forester: CHECK ENGINE warning light/Malfunction indicator light / If the light illuminates steadily
If the light illuminates steadily while driving
or does not turn off after the engine starts,
an emission control system malfunction
has been detected.
You should have your vehicle checked by
an authorized SUBARU dealer immediately.
NOTE
This light also illuminates when the fuel
filler cap is not tightened until it clicks.
If you have recently refueled your vehicle,
the cause of the CHECK ENGINE warning
light/malfunction indicator light illuminating
could be a loose or missing fuel filler cap.
Remove the cap and retighten it until it
clicks. Make sure nothing is interfering with
the sealing of the cap. Tightening the cap
will not make the CHECK ENGINE warning
light turn off immediately. It may take
several driving trips. If the light does not
turn off, take your vehicle to your authorized
SUBARU dealer immediately.
If the light is blinking while driving, an
engine misfire condition has been detected
which may damage the emission
control system.
To prevent serious damage to the emission
control system, you should do the
following...
Other information:
Parking Safety
Driver Assistance
Parking Safety
Rear Safety
While the ignition system or power button is ON, navigate to Setup > Vehicle > Driver Assistance > Parking Safety directly on the main infotainment system touchscreen of your Kia Telluride...
NOTE
If you unlock the driver’s door with a
key (including an emergency key) and
open the door while the alarm system is
armed, the alarm system is triggered
and the vehicle’s horn sounds. In this
case, perform any of the following
operations:
Models with “keyless access with
push-button start system”:
Press any button on the access
key fob (except when the access
key fob battery is discharged)...