Subaru Forester: Consumer information and reporting safety defects / Reporting safety defects (U.S.A.)
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying Subaru of America, Inc.
If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign. However, NHTSA cannot become involved in individual problems between you, your dealer, or Subaru of America, Inc.
To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1- 888-327-4236 (TTY: 1-800-424- 9153); go to
http://www.safercar.gov; or write to: Administrator, NHTSA, 1200 New Jersey Avenue, SE, West Building, Washington, DC 20590. You can also obtain other information about motor vehicle safety from http://www.safercar.gov.
How to contact Transport Canada in order to report a safety concern relating
to the vehicle (Canada)
..
Other information:
Subaru Forester 2019-2025 Owners Manual: Key positions
CAUTION Do not turn the ignition switch to the “START” position while the engine is running. NOTE To turn the key from the “ACC” to “LOCK” position, the select lever must be in the “P” position and the key must be pushed in and turned...
Subaru Forester 2019-2025 Owners Manual: How to change the headlight mode manually
Change to the low beam: When you return the turn signal lever to the center position, the high beam assist function will turn off and the high beam assist indicator light will turn off. Change to the high beam: When you turn the light control switch to the position, the headlight mode will be changed to the high beam...
Categories
- Manuals Home
- Subaru Forester Owners Manual
- Subaru Forester Service Manual
- To activate/deactivate the X-MODE
- RAB warning light (if equipped)
- How to use the high beam assist function
- New on site
- Most important about car
Average vehicle speed
This display shows the average vehicle speed since the trip meter was last reset. Pressing the TRIP RESET switch toggles the display between the average vehicle speed corresponding to the A trip meter display and the average vehicle speed corresponding to the B trip meter display. When either of the trip meter displays is reset, the corresponding average vehicle speed value is also reset.
