Subaru Forester: Driving information display / Average fuel consumption
- Displays the driving range per gallon of fuel
- Displays the driving range per liter of fuel
- Displays the fuel consumption per 100 km
This display shows the average rate of fuel consumption since the trip meter was last reset.
- TRIP RESET switch
Press the TRIP RESET switch to switch between the displays for the average fuel consumption that corresponds to the A trip meter mileage and the average fuel consumption that corresponds to the B trip meter mileage.
When the trip meter displays is reset, the corresponding average fuel consumption value is also reset.
NOTE
When the trip meter display is reset, the average fuel consumption corresponding to that trip meter display is not shown until the vehicle has subsequently covered a distance of 1 mile (or 1 km).
Current fuel consumption
Displays the driving range per gallon of
fuel
Displays the driving range per liter of fuel
Displays the fuel consumption per 100
km
This indication shows the rate of fuel
consumption at the present moment...
Other information:
Subaru Forester 2019-2025 Owners Manual: Tire pressure monitoring system (TPMS) (U.S.-spec. models)
The tire pressure monitoring system provides the driver with the warning message indicated by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire pressure monitoring system will activate only when the vehicle is driven...
Subaru Forester 2019-2025 Owners Manual: System servicing
WARNING When discarding a seatbelt retractor assembly or scrapping the entire vehicle damaged by a collision, consult your SUBARU dealer. Tampering with or disconnecting the system’s wiring could result in accidental activation of the seatbelt pretensioner and/or SRS airbag or could make the system inoperative, which may result in serious injury...
Categories
- Manuals Home
- Subaru Forester Owners Manual
- Subaru Forester Service Manual
- All-Wheel Drive warning light
- Unlock using PIN Code Access
- RAB warning light (if equipped)
- New on site
- Most important about car
Driving information display
NOTE
You can set the units for both the multifunction display (black and white) and the combination meter at the same time. For details about setting the language and units, refer to “Type A combination meter” or “Menu screens”.
