Subaru Forester: Electronic Parking Brake (EPB) / EPB malfunction indicator
When the vehicle is switched to the ON position and the Electronic Parking Brake system is operating normally, the indicator light shown below illuminates briefly for approximately three seconds before turning off.
|
If the EPB malfunction indicator illuminates while driving, or fails to illuminate during the normal self-check when the vehicle is placed in the ON position, the Electronic Parking Brake system may require inspection. Have your Kia Telluride checked by an authorized Kia dealer as soon as possible.
If the ESC warning indicator is illuminated because the Electronic Stability Control system has a malfunction, the EPB malfunction indicator may also illuminate. This does not necessarily indicate a fault with the Electronic Parking Brake itself.
NOTE
The EPB warning light may illuminate if the EPB switch operates abnormally. Turn the engine off, wait several minutes, and restart the vehicle. If the warning disappears, the switch has returned to normal operation. If the warning remains illuminated, have your Kia Telluride inspected by an authorized Kia dealer.
If the EPB warning light flashes or does not illuminate after pulling up the EPB switch, the Electronic Parking Brake has not been successfully applied.
If the warning light continues to blink, press the EPB switch down, then pull it upward again. If the indicator still does not turn off, have the vehicle inspected by an authorized Kia dealer.
When the EPB is not released
If the EPB cannot be released normally, do not attempt to drive the vehicle. Transport your Kia Telluride on a flatbed tow truck and have the Electronic Parking Brake system inspected by an authorized Kia dealer.
AUTO HOLD
The AUTO HOLD feature automatically keeps your Kia Telluride stationary after it has come to a complete stop, allowing you to remove your foot from the brake pedal while the vehicle remains securely held in place until you are ready to drive again...
Other information:
Subaru Forester 2019-2026 Owners Manual: Registration of the reverse tiltdown mirror angle with button “1” or “2”
CAUTION Depress the brake pedal when registering the reverse tilt-down mirror angle. Move the select lever to the “R” position, then the outside mirror angle will move to the reverse tilt-down position. Adjust the outside mirror angle. For details about the settings, refer to “Remote control mirror switch”...
Subaru Forester 2019-2026 Owners Manual: Operation
NOTE The rear gate will remain unlocked even after closing it. Always lock the rear gate when leaving the vehicle. If you cannot open/close the rear gate by performing the operation described here, a short electronic chirp will sound three times (beep, beep, beep)...
Categories
- Manuals Home
- Subaru Forester Owners Manual
- Subaru Forester Service Manual
- Reverse Automatic Braking (RAB) system ON/OFF setting
- Low fuel warning light
- Vehicle load limit – how to determine
- New on site
- Most important about car
Windshield wiper and washer switches
The wiper operates only when the ignition switch is in the “ON” or “ACC” position.
