Subaru Forester: Wiper and washer / Windshield wiper and washer switches
The wiper operates only when the ignition
switch is in the “ON” or “ACC” position.
WARNING
In freezing weather, do not use the
windshield washer until the windshield
is sufficiently warmed by the
defroster.
Otherwise the washer fluid can
freeze on the windshield, blocking
your view.
CAUTION
Do not operate the washer continuously
for more than 10 seconds,
or when the was..
/ MIST: Mist (for a single wipe)
/ OFF: Off
/ INT: Intermittent
/ LO: Low speed
/ HI: High speed
To turn the wipers on, push the wiper
control lever down...
Other information:
Replace the wiper blade rubber according to the following procedure.
Slit
Pull the wiper blade rubber from the
right side in the order of (1), (2) and (3) until
the slit on the wiper blade can be seen
position.
Pull the end of the wiper blade rubber
through the slit to remove it...
Select the airflow mode using the airflow
mode selection dial (type A and C) or the
airflow mode selection button (type B).
Airflow modes are as follows.
If equipped
Ventilation: Instrument panel outlets
If equipped
Ventilation 2 for type B and C: Instrument
panel outlets and foot outlets
If equipped
Bi-level: Instrument panel outlets and foot outlets
If equipped
Heat: Foot outlets, both side outlets of the
instrument panel and some through windshield
defroster outlets (A small amount of
air flows to the windshield and both side
windows to prevent fogging...