Subaru Forester: Windshield wiper and washer switches / Windshield washer
To wash the windshield, pull the wiper control lever toward you. The washer fluid sprays until you release the lever. The wipers operate while you pull the lever.
NOTE
Windshield washer fluid warning light
The windshield washer fluid warning light illuminates when the washer fluid level in the tank has dropped to the lower limit. If the warning light illuminates, refill the tank with fluid. For the refilling procedure, refer to “Windshield washer fluid”.
Rear window wiper and washer switch
: Washer operation (accompanied by
wiper operation)
: Continuous operation
: Intermittent operation
: Off
: Washer operation (accompanied
by wiper operation)..
Other information:
Subaru Forester 2019-2026 Owners Manual: Ignition switch light (if equipped)
For easy access to the ignition switch in the dark, the ignition switch light illuminates when the driver’s door is opened or when the driver’s door is unlocked using the remote keyless entry transmitter. The light remains illuminated for several tens of seconds and then gradually turns off under the following conditions...
Kia Telluride (LQ2, 2027-2026) Owner's Manual: Direct Oncoming function
The Direct Oncoming function of Forward Collision-Avoidance Assist helps monitor vehicles approaching from the opposite direction. In the Kia Telluride, this function may respond through the following operating stages: Collision Warning Emergency Braking Stopping vehicle and ending brake control Collision Warning Collision Warning Collision Warning can alert the driver with a blinking Forward Safety warning light (), a warning message, an audible warning, and steering wheel vibration when the system identifies a possible direct oncoming collision...
Categories
- Manuals Home
- Reverse Automatic Braking (RAB) system ON/OFF setting
- Alarm system setting
- Power steering warning light
- New on site
- Most important about car
Average vehicle speed
This display shows the average vehicle speed since the trip meter was last reset. Pressing the TRIP RESET switch toggles the display between the average vehicle speed corresponding to the A trip meter display and the average vehicle speed corresponding to the B trip meter display. When either of the trip meter displays is reset, the corresponding average vehicle speed value is also reset.
