Subaru Forester 2019-2026 Owners Manual / Instruments and controls / Light control switch / High/low beam change (dimmer)
Subaru Forester: Light control switch / High/low beam change (dimmer)
- High beam
- Low beam
When the headlights are on high beam, the
high beam indicator light 
on the
combination meter is also on.
Headlight flasher
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it...
Other information:
Subaru Forester 2019-2026 Owners Manual: Operating ranges
Antennas Operating range (approximately 16 to 32 in (40 to 80 cm)) LED indicator When the access key fob is within either of the operating ranges of the front doors, the LED indicator on the access key fob flashes. When the keyless access functions are disabled, the LED indicator does not flash unless a button on the access key fob is pressed...
Subaru Forester 2019-2026 Owners Manual: Memory function
Memory switch Memory switch status ON status OFF status Your desired rear gate height can be registered. Registration of the rear gate height: To register the rear gate height, perform the following procedures while the ignition switch is in the “LOCK”/“OFF” position...
Categories
- Manuals Home
- Subaru Forester Owners Manual
- Subaru Forester Service Manual
- Changing a flat tire
- Low fuel warning light
- How to use the high beam assist function
- New on site
- Most important about car
Driving information display
NOTE
You can set the units for both the multifunction display (black and white) and the combination meter at the same time. For details about setting the language and units, refer to “Type A combination meter” or “Menu screens”.
Copyright © 2026 www.suforester5.com