Subaru Forester: Towing / Towing hooks. Front towing hook
The towing hooks should be used only in an emergency.
CAUTION
Use only the specified towing hooks and tie-down hooks/holes. Never use suspension parts or other parts of the body for towing or tie-down purposes.
Front towing hook
- Take the towing hook, screwdriver and
jack handle out of the cargo area.
- Cover the tip of a flat-head screwdriver
with vinyl tape or cloth so that it will not
scratch the bumper. Insert the flat-head
screwdriver into the cutout of the cover and
pry open the cover.
- Screw the towing hook into the thread
hole until its thread can no longer be seen.
- Tighten the towing hook securely using the jack handle.
After towing, remove the towing hook from the vehicle and stow it in the tool bucket. Fit the towing hook cover on the bumper.
WARNING
Do not use the towing hook except when towing your vehicle. . Be sure to remove the towing hook after towing. Leaving the towing hook mounted on the vehicle could interfere with proper operation of the SRS airbag system in a frontal collision.
CAUTION
To prevent deformation to the bumper and the towing hook, do not apply excessive load to the towing hook.
Towing
I..
Rear towing hook
Take the towing hook and screwdriver
out of the tool bucket. Take the jack handle
out of the cargo area.
Cover the tip of a flat-head screwdriver
with vinyl tape or cloth so that it will not
scratch the bumper...
Other information:
Subaru Forester 2019-2026 Owners Manual: Remote transmitter program (Remote engine starter transceiver)
New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional transmitters are desired (the system will accept up to eight transmitters). New remote engine start transmitters can be programmed according to the following procedure...
Subaru Forester 2019-2026 Owners Manual: Front seat heater
Front seats HI – Rapid heating LO – Normal heating Off Left-hand side Right-hand side To turn on the seat heater, push the “LO” or “HI” position on the switch, as desired, depending on the temperature. Selecting the “HI” position will cause the seat to heat up quicker...
Categories
- Manuals Home
- Subaru Forester Owners Manual
- Subaru Forester Service Manual
- Changing a flat tire
- To activate/deactivate the X-MODE
- How to use the high beam assist function
- New on site
- Most important about car
Outside temperature indicator
The outside temperature is displayed on the multi-function display (color LCD).
NOTE
The outside temperature indicator shows the temperature around the sensor. However, the temperature may not be indicated correctly or the update may be delayed in the following conditions. While parking or driving at low speeds When the outside temperature changes suddenly (example: when going in and out of an underground parking area or when passing through a tunnel) When starting the engine after being parked for a certain period of time The temperature unit cannot be changed.