Subaru Forester: Driver Monitoring System ON/OFF settings / Automatically retract seat on entry
The automatically retract seat on entry
which automatically slides back the driver’s
seat when the driver’s door is
unlocked and opened. This function can
be turned ON/OFF. For the setting procedure,
refer to “Driver Monitoring System
settings”.
CAUTION
Wait until the seat automatic retraction
is fully completed before sitting
in the driver’s seat.
NOTE
- If the seat position is not registered
in the access key fob memory, the
automatically retract seat on entry
function can be used.
- Even when the automatically retract
seat on entry setting is ON, the automatically
retract seat on entry function
automatically turns OFF when the user
recognition function is OFF.
- Automatically retract seat on entry
cannot be selected when the Driver
Monitoring System OFF indicator, Driver
Monitoring System temporary stop
indicator, or Driver Monitoring System
warning is illuminated.
- This function will operate if the seat
is in front of the center of the seat
sliding mechanism.
U.S.-spec. models
CAUTION
FCC WARNING
Changes or modifications not expressly
approved by the party responsible
for compliance could void
the user’s authority to operate the
equipment...
Other information:
WARNING
To avoid serious personal injury
caused by entrapment, always conform
to the following instructions
without exception.
When operating the power windows,
be extremely careful to
prevent anyone’s body parts or
any other objects from being
caught in the window...
Temperature control
Turn the temperature control dial to set the
preferred interior temperature.
NOTE
The controllable temperature range
may vary depending on the regional
specifications of the vehicle.
SYNC mode (type B)
When the SYNC mode is turned on, both
the driver’s and front passenger’s side
temperatures are synchronized using the
driver’s side temperature control dial...
Categories

When units in miles is selected
When units in km is selected
This display shows the average vehicle
speed since the trip meter was last reset.
Pressing the TRIP RESET switch toggles
the display between the average vehicle speed corresponding to the A trip meter
display and the average vehicle speed
corresponding to the B trip meter display.
When either of the trip meter displays is
reset, the corresponding average vehicle
speed value is also reset.
read more