Subaru Forester: Driver assistance guide / Blind-spot Collision-avoidance Assist (BCA)

The detection range may vary depending on your vehicle speed. Even when another vehicle is present in the blind spot area, Blind-Spot Collision-avoidance Assist may not provide a warning if you pass other vehicles at high speed.

The timing of the warning may vary when another vehicle approaches the blind spot area at high speed.

Never disassemble, modify, or damage the detection sensor assembly.

If the detection sensor or the area around it has been damaged or impacted, Blind-Spot Collision-avoidance Assist may not operate properly even when no warning message appears on the instrument cluster. Have the function inspected by an authorized Kia dealer.

If any detection sensor has been replaced or repaired, have the Kia Telluride inspected by an authorized Kia dealer to confirm proper system operation.

If paint is applied to the bumper area where the rear corner radar sensors are installed, or if that bumper area is changed, Blind-Spot Collision-avoidance Assist may not function properly. Use only Kia Genuine Parts or replacement parts of an equivalent standard with proven quality and performance when repairing or replacing the bumper.

Do not install a license plate frame, bumper sticker, film, bumper guard, or similar object near the rear corner radar area.

Blind-Spot Collision-avoidance Assist may not work correctly if the bumper has been replaced, if the area around the rear corner radar has been damaged, or if paint has been applied near the radar sensors.

Installing a trailer, carrier, or similar equipment may negatively affect rear corner radar performance and may prevent Blind-Spot Collision-avoidance Assist from operating properly.