Kia Telluride (LQ2, 2027-2026) Owner's Manual / Driver assistance guide / Forward Collision-avoidance Assist (FCA) (Sensor Fusion) / Forward Collision-avoidance Assist operation / Direct Oncoming function

Subaru Forester: Forward Collision-avoidance Assist operation / Direct Oncoming function

The Direct Oncoming function of Forward Collision-Avoidance Assist helps monitor vehicles approaching from the opposite direction. In the Kia Telluride, this function may respond through the following operating stages:

Collision Warning
Emergency Braking
Stopping vehicle and ending brake control

Collision Warning


	Collision Warning

Collision Warning can alert the driver with a blinking Forward Safety warning light (), a warning message, an audible warning, and steering wheel vibration when the system identifies a possible direct oncoming collision.

Collision Warning may activate under the following conditions:

Your speed is approximately 19-80 mph (30-130 km/h) (*if equipped: 6-80 mph (10-130 km/h)).
The oncoming vehicle speed is above approximately 6 mph (10 km/h).

Emergency Braking


	Emergency Braking

Emergency Braking can alert the driver with a blinking Forward Safety warning light (), a warning message, an audible alert, and steering wheel vibration. If the risk continues to increase, the system may apply braking assistance to help reduce collision speed.

Emergency Braking may activate under the following conditions:

Your driving speed is approximately 19-80 mph (30-130 km/h).
The oncoming vehicle speed is above approximately 6 mph (10 km/h).
When the detected object enters the operating range of the Direct Oncoming function.

Stopping vehicle and ending brake control


	Drive carefully

When Emergency Braking stops your vehicle, a warning message appears on the instrument cluster.

For safety, press the brake pedal immediately and check the vehicle's surroundings before moving again.

Brake control ends approximately 2 seconds after Emergency Braking stops your vehicle.

WARNING

If your vehicle or the oncoming vehicle is not traveling straight, the Direct Oncoming function warning and control may be delayed or may not operate.

When driving at night, motorcycle detection performance may decrease. As a result, Forward Collision-Avoidance Assist may be temporarily limited or may not operate as expected.

TIP

Press the hazard warning light button to turn the warning sound OFF during Collision Warning and Emergency Braking.

Junction Turning function

T..

Junction Crossing function: (if equipped)

The Junction Crossing function of Forward Collision-Avoidance Assist is designed to help the driver when moving through an intersection where another vehicle may approach from the left or right...

Other information:

Subaru Forester 2019-2026 Owners Manual: To Operate the Compass Feature

To turn the compass feature on/off, press and hold the switch for more than 3 seconds or until the display turns on/off. The compass feature will default to on with each ignition cycle. If the display reads “C”, slowly drive the vehicle in circles until compass is calibrated...

Kia Telluride (LQ2, 2027-2026) Owner's Manual: Horn

To sound the horn on your Kia Telluride, press the center section of the steering wheel marked with the horn symbol, as shown in the illustration. The horn functions only when pressure is applied to the designated area of the steering wheel...