Subaru Forester: Locking and unlocking by holding the access key fob / Door unlock selection function
When the door is unlocked using the
keyless access function, only the doors
that were set can be unlocked.
The settings can be changed with the
following methods.
- The setting can be changed by operating
the combination meter display (color
LCD). Refer to “Keyless Entry System”.
- The setting can be changed by a
SUBARU dealer.
When all doors including the rear gate are
locked, you can unlock the doors (including
rear gate) without a key by pressing the
rear lock button.
Rear lock button
NOTE
PIN Code Access will be helpful if the
key fob is accidentally left in the
vehicle...
Other information:
To turn the compass feature on/off,
press and hold the switch for
more
than 3 seconds or until the display turns
on/off. The compass feature will default to
on with each ignition cycle.
If the display reads “C”, slowly drive the
vehicle in circles until compass is calibrated...
Check the towing regulations for trailer
or caravan vehicles that vary by state/
region. Failure to comply with the procedures
set forth will not only compromise
your safety, but will also negate your
insurance coverage and/or may violate
the state road and traffic acts and regulations...
Categories
The outside temperature is displayed on
the multi-function display (color LCD).
NOTE
The outside temperature indicator
shows the temperature around the
sensor. However, the temperature may
not be indicated correctly or the update
may be delayed in the following conditions.
While parking or driving at low
speeds
When the outside temperature
changes suddenly (example: when
going in and out of an underground
parking area or when passing
through a tunnel)
When starting the engine after
being parked for a certain period of
time
The temperature unit cannot be
changed.
read more