Subaru Forester 2019-2026 Owners Manual / Instruments and controls / Mirrors / Using HomeLink / Erasing HomeLink Buttons

Subaru Forester: Using HomeLink / Erasing HomeLink Buttons

To erase programming from the three buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted:

Press and hold the two outer HomeLink buttons for at least 10 seconds. The LED indicator will change from continuously lit to rapidly flashing. Release both buttons. Do not hold for longer than 20 seconds. HomeLink is now ready to be programmed at any time beginning with “Programming a New HomeLink Button” - step 1.

Using HomeLink

T..

Reprogramming a Single HomeLink Button

To program a previously trained button, follow these steps: Press and hold the desired HomeLink button. DO NOT release the button. The indicator light will begin to slowly flash orange after 20 seconds...

Other information:

Subaru Forester 2019-2026 Owners Manual: Coolant temperature low indicator light/Coolant temperature high warning light

CAUTION After turning the ignition switch to the “ON” position, if this indicator light/warning light behaves in any of the following ways, the electrical system may be malfunctioning. Contact your SUBARU dealer immediately for an inspection...

Subaru Forester 2019-2026 Owners Manual: Automatic climate control operation

When this mode is selected, the fan speed, airflow distribution, air-inlet control, and air conditioner compressor operation are automatically controlled. To activate this mode, perform the following. NOTE Operate the automatic climate control system when the engine is running...