Subaru Forester: Instruments and controls / Mirrors
Always check that the inside and outside mirrors are properly adjusted before you start driving.
- Inside mirror
- Auto-dimming mirror/compass with HomeLink® (if equipped)
- HomeLink® Wireless Control System
- Programming a New HomeLink Button
- Gate Operator/Canadian Programming
- Using HomeLink
- Outside mirrors
Washer
T..
Inside mirror
Normal position
Anti-glare position
Push the tab on the mirror for normal use.
To reduce glare from the headlights of the
vehicle behind you, pull the tab to the antiglare
position...
Other information:
Subaru Forester 2019-2026 Owners Manual: Type A combination meter
Various adjustments can be made, such as switching units shown on the combination meter and adjusting the warning tone volume. While the ignition switch is in the “OFF” position, each press of TRIP RESET switch results in items shown in the table below being switched...
Subaru Forester 2019-2026 Owners Manual: Operating conditions
The BSD/RCTA will operate when all of the following conditions are met. The ignition switch is in the “ON” position. The BSD/RCTA warning light and BSD/ RCTA OFF indicator light are turned off. The EyeSight warning indicator is off. The vehicle is driven at speeds above 7 mph (12 km/h) (except when reversing)...
Categories
- Manuals Home
- Subaru Forester Owners Manual
- Subaru Forester Service Manual
- If the passenger’s frontal airbag OFF indicator illuminates and the ON indicator turns off even when the front passenger’s seat is occupied by an adult
- All-Wheel Drive warning light
- To activate/deactivate the X-MODE
- New on site
- Most important about car
Driving information display
NOTE
You can set the units for both the multifunction display (black and white) and the combination meter at the same time. For details about setting the language and units, refer to “Type A combination meter” or “Menu screens”.
Copyright © 2026 www.suforester5.com