Subaru Forester: Locking and unlocking by holding the access key fob / Operating ranges
- Antennas
- Operating range (approximately 16 to 32
in (40 to 80 cm))
- LED indicator
When the access key fob is within either of
the operating ranges of the front doors, the
LED indicator on the access key fob
flashes. When the keyless access functions
are disabled, the LED indicator does
not flash unless a button on the access key
fob is pressed.
NOTE
- If the access key fob is placed too
close to the vehicle body, the keyless
access functions may not operate
properly. If it does not operate properly,
repeat the operation from farther away.
- If the access key fob is placed near
the ground or in an elevated location
from the ground, even if it is in the
indicated operating range, the keyless
access function may not operate properly.
- When the access key fob is within
the operating range, it is possible for
anyone, even someone who is not
carrying the access key fob, to operate
the keyless access function. Note that
the keyless access function can be
operated only by the door handle, door
lock sensor, rear gate opener button or
rear lock button in the operating range
in which the access key fob is detected.
- It is not possible to lock the doors,
rear gate and fuel filler lid using the
keyless access function when the access
key fob is inside the vehicle.
However, depending on the status of
the access key fob and the environmental
conditions, the access key fob
may be locked inside the vehicle.
Before locking the vehicle, make sure
that you have the access key fob.
- When the battery of the access key
fob is discharged, or when operating it
in a location with strong radio waves or
noise (e.g., near a radio tower, power
plant, broadcast station or an area
where wireless equipment is used), or
while talking on a cell phone, the
operating ranges may be reduced, or
the keyless access function may not
operate.
- In such a case, perform the procedure described in “Locking and
unlocking”.
- The doors may lock or unlock when
the car is being washed or exposed to a
significant amount of water that contacts
the door handle while the key fob
is still in the operating range.
It is possible to perform the following
operations when you are carrying the
access key fob.
Lock and unlock the doors.
Lock and unlock the rear gate...
Other information:
NOTE
For remote engine starter transceiver:
In the event that the vehicle’s battery is
replaced, discharged or disconnected,
it will be necessary to start the vehicle a
minimum of one time using the key
prior to activating the remote engine
start system...
CAUTION
Do not turn the ignition switch to the
“START” position while the engine
is running.
NOTE
To turn the key from the “ACC” to
“LOCK” position, the select lever must
be in the “P” position and the key must
be pushed in and turned...