Subaru Forester: Rear window wiper and washer switch / Rear wiper

With the switch turned to the Subaru Forester. Rear wiper position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed. In this position, when you move the select lever to the “R” position, the rear wiper will switch to continuous operation. When you move the select lever from the “R” (reverse) position to another position, the rear wiper will return to intermittent operation.

Reverse gear interlocked rear wiper:

Even if the rear wiper switch is in the off Subaru Forester. Rear wiper position, if the front windshield wiper is operating continuously, the rear wiper will operate intermittently when you move the select lever to the “R” (reverse) position.

The factory setting (default setting) of the reverse gear interlocked rear wiper is as follows.

  • U.S.-spec. models: Non-operational
  • Other models: Operational

This setting can be changed by a SUBARU dealer. Consult your SUBARU dealer for details.

CAUTION

Do not attach anything that disturbs the rear wiper operation on the rear gate. Doing so may damage the rear wiper when it operates.

    Rear window wiper and washer switch

    ..

    Washer

    To wash the rear window while the rear wiper is operating, turn the knob switch upward to the position. The washer fluid sprays until you release the knob...

    Other information:

    Subaru Forester 2019-2025 Owners Manual: Unfastening the seatbelt


    Button   Push the release button of the center seatbelt buckle (on the left-hand side) to unfasten the seatbelt.NOTE When the seatback is folded down, it is necessary to disconnect the connector. Insert a tongue plate or other hard pointed object into the slot in the anchor buckle on the right-hand side and push it in...

    Subaru Forester 2019-2025 Owners Manual: Welcome screen (opening animation) and Good-bye (ending animation) screen


    When the driver’s door is opened and closed after unlocking the door, the welcome screen (opening animation) will appear on the combination meter display (color LCD) for approximately 20 seconds. When the ignition switch is turned to the “LOCK”/“OFF” position, the combination meter display (color LCD) gradually turns off by showing Good-bye screen (ending animation)...

    Categories

    Outside temperature indicator

    The outside temperature is displayed on the multi-function display (color LCD).

    NOTE

    The outside temperature indicator shows the temperature around the sensor. However, the temperature may not be indicated correctly or the update may be delayed in the following conditions. While parking or driving at low speeds When the outside temperature changes suddenly (example: when going in and out of an underground parking area or when passing through a tunnel) When starting the engine after being parked for a certain period of time The temperature unit cannot be changed.

    read more

     
    Copyright © 2025 www.suforester5.com