Subaru Forester: Parking your vehicle / Automatic release function by accelerator pedal
The parking brake will be automatically
released by depressing the accelerator
pedal. However, the automatic release
function does not operate under the
following conditions.
- Any door (other than the rear gate) is
open.
- The driver’s seatbelt is not fastened.
If the parking brake is automatically
released, the electronic parking brake
indicator light and the indicator light on
the parking brake switch turn off.
Parking brake switch
Indicator light
Release the electronic parking brake
Apply the electronic parking brake
WARNING
Before exiting the vehicle, make
sure that you turn off the engine.
Otherwise, the parking brake may
be released and an accident may
occur.
If the brake system warni..
The Auto Vehicle Hold function will automatically
keep the vehicle stopped even
after releasing the brake pedal when the
vehicle is at a complete stop, such as at
traffic signals...
Other information:
In the event that there are still programming
difficulties or questions, additional
HomeLink information and programming
videos can be found at
www.HomeLink.com, www.youtube.com/HomeLinkGentex,
or by calling the toll-free HomeLink-hotline
at 1-800-355-3515...
WARNING
When returning the seatback to
its original position, observe the
following precaution.Failure to observe the precaution
may damage the seatbelt, impairing
its effectiveness, and possibly
result in a serious injury.
When returning the seatback to
its original position, pull the
seatbelt out towards the vehicle
exterior so that it will not be
caught between the seatback
and the trim...