Subaru Forester: BSD/RCTA (if equipped) / Certification for the BSD/RCTA
U.S.-spec. models
FCC ID: OAYSRR3A
CAUTION
FCC WARNING
Changes or modifications not expressly
approved by the party responsible
for compliance could void
the user’s authority to operate the
equipment.
NOTE
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
Canada-spec. models


Mexico-spec. models

Sensors
The radar sensors, one on each side of the
vehicle, are mounted inside the rear
bumper.
To ensure correct operation of the BSD/RCTA, observe the following
precautions...
Other information:
Gross Axle Weight
The total weight applied to each axle
(GAW) must never exceed the Gross Axle
Weight Rating (GAWR). The front and rear
GAWs can be adjusted by relocating
passengers and luggage inside the vehicle.
The front and rear GAWR of your
vehicle that is given by SUBARU are also
shown on the certification label located at
the bottom of driver’s side door pillar...
NOTE
This section is applicable to the front
seatbelt.
Seatbelt retractor assembly (shoulder
belt pretensioner and adaptive force
limiter)
Lap belt pretensioner
The shoulder belt pretensioner is supplemented
by a lap belt pretensioner, which is
located at the base of the center pillar...