Subaru Forester: Inside rearview mirror / FCC (USA) and ISED (Canada) Compliance

This sophisticated communication device installed in your Kia Telluride strictly complies with FCC rules (Part 15) and the Innovation, Science, and Economic Development (ISED) Canada RSS-210 standards. The operation of this equipment is governed by the following two conditions: (1) The device must not produce harmful interference, and (2) it must be capable of accepting any incoming interference, including interference that might result in unintended or undesired operation. WARNING: This transmitter has undergone rigorous testing and meets all applicable FCC and ISED regulatory requirements. Please be aware that any unauthorized changes or modifications not expressly approved by the party responsible for regulatory compliance could void your authority to operate this equipment.

This equipment has been designed and tested to comply with established FCC and ISED radiation exposure limits for use in an uncontrolled environment. To ensure continued compliance, all end users must strictly follow the specific operating instructions provided for RF exposure safety. This transmitter must always be maintained at a minimum distance of 8 inches (20 cm) from the user during operation and must not be co-located or used in conjunction with any other antenna or transmitter system.

    Electrochromic Mirror (ECM) with HomeLink® System (if equipped)

    ..

    HomeLink® 5 programming flow chart

    ..

    Other information:

    Kia Telluride (LQ2, 2027-2026) Owner's Manual: Adjusting the Outside Rearview Mirrors


    The electronic remote control switch located on the door panel allows for precise adjustment of both the left and right outside rearview mirrors in your Kia Telluride, ensuring a perfect view every time. To customize your mirror settings, follow these simple steps: Move the primary switch selector to either the 'R' or 'L' position to activate the corresponding right or left outside rearview mirror...

    Subaru Forester 2019-2026 Owners Manual: Window side seating position


    Head restraint Release button To remove: Press the release button, and pull out the head restraint. To install: Push the head restraint into the holes on the top of the seatback until it locks. Press and hold the release button to lower the head restraint...

    Categories

    Driving information display

    NOTE

    You can set the units for both the multifunction display (black and white) and the combination meter at the same time. For details about setting the language and units, refer to “Type A combination meter” or “Menu screens”.

    read more

     
    Copyright © 2026 www.suforester5.com