Subaru Forester: Warning and indicator / Icy road surface warning light (if equipped)

Subaru Forester. Icy road surface warning light (if equipped)

When the outside temperature is 378F (38C) or less, the icy road surface warning will illuminate to inform the driver that the road surface may be frozen.

NOTE

  • The outside temperature indicator shows the temperature in the area around the sensor. However, the temperature may not be indicated correctly or the update may be delayed in the following conditions.
    • While parking or driving at low speeds
    • When the outside temperature changes suddenly (example: when going in and out of an underground parking area or when passing through a tunnel)
    • When starting the engine after being parked for a certain period of time
  • The icy road surface warning screen should be treated only as a guide. Be sure to check the condition of the road surface before driving.
  • Once the icy road surface warning screen appears, it will not disappear unless the outside temperature has increased to 418F (58C) or higher.

    Driver Monitoring System temporary stop indicator light (if equipped)

    ..

    Combination meter display (color LCD) (if equipped)

    WARNING Always pay adequate attention to safe driving when operating the combination meter display (color LCD) while the vehicle is in motion. When operation of the combination meter display (color LCD) interferes with your ability to concentrate on driving, stop the vehicle before performin..

    Other information:

    Subaru Forester 2019-2024 Owners Manual: Floor mat


    CAUTION If the floor mat slips forward and interferes with the movement of the pedals during driving, it could cause an accident. Observe the following precautions to prevent the floor mat from slipping forward. Be sure to use a genuine SUBARU floor mat or an equivalent designed with grommets in the correct locations...

    Subaru Forester 2019-2024 Owners Manual: How to temporarily lower the sensitivity of the high beam assist function


    The sensitivity of the high beam assist function can be lowered by performing the following operations. Before turning the ignition switch to the “ON” position, set the light control switch to the “AUTO” position and push the signal lever forward (high beam position)...

    Categories

    Outside temperature indicator

    The outside temperature is displayed on the multi-function display (color LCD).

    NOTE

    The outside temperature indicator shows the temperature around the sensor. However, the temperature may not be indicated correctly or the update may be delayed in the following conditions. While parking or driving at low speeds When the outside temperature changes suddenly (example: when going in and out of an underground parking area or when passing through a tunnel) When starting the engine after being parked for a certain period of time The temperature unit cannot be changed.

    read more

     
    Copyright © 2024 www.suforester5.com