Subaru Forester: Light control switch / How to change the headlight mode manually
Change to the low beam:
When you return the turn signal lever to the
center position, the high beam assist
function will turn off and the high beam
assist indicator light will turn off.
Change to the high beam:
When you turn the light control switch to
the
position, the headlight mode
will
be changed to the high beam.
At this time, the high beam assist function
will turn off, the high beam assist indicator
light will turn off and the high beam
indicator light will turn on.
NOTE
- After manually changing the headlight
mode to the high beam, if you turn
on the high beam assist function,
return the light control switch to the
“AUTO” position.
- When manually changing the headlight
mode to the high beam, if you turn
the light control switch to the
position, the instrument panel illumination,
parking lights, front side marker
lights, rear side marker lights, tail lights
and license plate lights will be on.
The high beam assist function recognizes
the conditions surrounding the vehicle
based on the brightness of illumination
ahead of your vehicle, etc...
Other information:
WARNING
When returning the seatback to
its original position, observe the
following precaution.Failure to observe the precaution
may damage the seatbelt, impairing
its effectiveness, and possibly
result in a serious injury.
When returning the seatback to
its original position, pull the
seatbelt out towards the vehicle
exterior so that it will not be
caught between the seatback
and the trim...
WARNING
When operating the power rear
gate, observe the following precautions.
Ignoring the precautions
may result in an injury (e.
g., anyone’s body is hit against
the rear gate or is caught in the
rear gate, etc.)
Make sure there are no people
around the rear gate...