Subaru Forester: Windows / Initialization of power window (windows with off delay function)
If the one-touch auto up and down function
or off delay function does not operate
properly, operate each window according
to the following procedure in order to
initialize the power window system.
- Close the door.
- Turn the ignition switch to the “ON”
position.
- Open the window completely and then
press and hold down the power window
switch for approximately 1 second.
- Close the window completely and then
pull and hold the power window switch for
approximately 1 second.
Other information:
Temperature control
Turn the temperature control dial to set the
preferred interior temperature.
NOTE
The controllable temperature range
may vary depending on the regional
specifications of the vehicle.
SYNC mode (type B)
When the SYNC mode is turned on, both
the driver’s and front passenger’s side
temperatures are synchronized using the
driver’s side temperature control dial...
Apply a flat-head screwdriver to the
light cover as shown in the illustration, and
pry the light cover off from the rear gate
trim.
Turn the bulb socket counterclockwise
and remove it.
Pull the bulb out of the bulb socket and
replace it.
Install the bulb socket by turning it
clockwise...