Subaru Forester: Continuously variable transmission / P (Park) / R (Reverse) / N (Neutral) / D (Drive) /
This position is for parking the vehicle and
starting the engine. In this position, the
transmission is mechanically locked to
prevent the vehicle from rolling freely.
When you park the vehicle, first apply the
parking brake firmly, then shift into the “P”
position. Do not hold the vehicle with only
the mechanical friction of the transmission.
To shift the select lever from the “P”
position to any other position, you should
depress the brake pedal fully then move
the select lever. This prevents the vehicle
from lurching when it is started.
This position is for backing the vehicle. To
shift from the “N” to “R” position, stop the
vehicle completely then move the lever to
the “R” position while pressing the select
lever button in...
Other information:
SRS airbag system warning light
A diagnostic system continually monitors
the readiness of the SRS airbag system
(including front seatbelt pretensioners)
with the ignition switch in the “ON” position.
The SRS airbag system warning light will
show normal system operation by illuminating
for approximately 6 seconds when
the ignition switch is turned to the “ON”
position...
CAUTION
Do not open and close the center
console lid while operating the rear
seat heater switch. There is the risk
of fingers being caught in the lid.
The seat heater operates when the ignition
switch is in the “ON” position.
Rear seat heater switch
HIGH mode indicators
LOW mode indicators
Left-hand side
Right-hand side
Press the rear seat heater switch...