Subaru Forester: Replacement of wiper blades / Rear window wiper blade assembly
- Raise the wiper arm off the rear
window.

- Turn the wiper blade assembly counterclockwise.

- Pull the wiper blade assembly toward
you to remove it from the wiper arm.
- Install the wiper blade assembly to the
wiper arm. Make sure that it locks in place.
- Hold the wiper arm by hand and slowly
lower it in position.
Pull out the end of the blade rubber
assembly to unlock it from the plastic
support.
Pull the blade rubber assembly out of
the plastic support...
Other information:
The tire pressure monitoring system provides
the driver with a warning message by
sending a signal from a sensor that is
installed in each wheel when tire pressure
is severely low. The tire pressure monitoring
system will activate only when the
vehicle is driven...
CAUTION
Do not turn the ignition switch to the
“START” position while the engine
is running.
NOTE
To turn the key from the “ACC” to
“LOCK” position, the select lever must
be in the “P” position and the key must
be pushed in and turned...