Subaru Forester: Replacement of wiper blades / Windshield wiper blade rubber
Replace the wiper blade rubber according to the following procedure.

- Slit
- Pull the wiper blade rubber from the
right side in the order of (1), (2) and (3) until
the slit on the wiper blade can be seen
position.

- Pull the end of the wiper blade rubber
through the slit to remove it.

- Insert a new wiper blade rubber into
the slit. Do not insert the wiper blade
rubber into the wrong slit.

- Insert the wiper blade rubber into the
slit, then return to the tip of the position.
- Check that the wiper blade rubber is
fixed properly. If wiper blade rubbers are
not attached properly, they may scratch
the windshield.
- Attach the wiper blade.
NOTE
It may be difficult to perform the wiper
blade rubber replacement. We recommend
that you contact your SUBARU
dealer for wiper blade rubber replacement
if necessary.
Raise the wiper arm off the rear
window.
Turn the wiper blade assembly counterclockwise.
Pull the wiper blade assembly toward
you to remove it from the wiper arm...
Other information:
CAUTION
Do not open and close the center
console lid while operating the rear
seat heater switch. There is the risk
of fingers being caught in the lid.
The seat heater operates when the ignition
switch is in the “ON” position.
Rear seat heater switch
HIGH mode indicators
LOW mode indicators
Left-hand side
Right-hand side
Press the rear seat heater switch...
Control switch
(Up)
/SET (Enter)
(Down)
By operating “” or “”
of the control
switch, the screens and selection items
can be switched. When the “ /SET”
switch is pulled toward you, the item can
be selected and set.
If there are some useful messages, such
as vehicle information, warning information,
etc...