Subaru Forester: Head restraints / Rear seats
Head restraints are installed in all secondrow
seats and can be adjusted as described
below.
The angle of the head restraint can be
adjusted in several steps. ..
Head restraint
Release button
To remove:
Press the release button, and pull out the
head restraint.
To install:
Push the head restraint into the holes on
the top of the seatback until it locks...
Other information:
Replace the wiper blade rubber according to the following procedure.
Slit
Pull the wiper blade rubber from the
right side in the order of (1), (2) and (3) until
the slit on the wiper blade can be seen
position.
Pull the end of the wiper blade rubber
through the slit to remove it...
Locking the doors
Press the lock/arm button to lock all doors,
the rear gate and fuel filler lid. An electronic
chirp will sound once and the hazard
warning flashers will flash once.
If any of the doors (or the rear gate) are not
fully closed, the following will occur to alert
you that the doors (or the rear gate) are not
properly closed...