Subaru Forester: SRS side airbag and SRS curtain airbag / SRS curtain airbag
Your vehicle is equipped with a SUBARU SRS curtain airbag system that complies with the Federal Motor Vehicle Safety Standard (FMVSS) No. 226.
The SRS curtain airbag on each side of the cabin is stored in the roof side (between the front pillar and a point over the rear seat). An “SRS AIRBAG” mark is located at the top of each center pillar.
In a moderate to severe side impact collision, the SRS curtain airbag on the impacted side of the vehicle deploys between the occupant and the side window and supplements the seatbelt by reducing the impact on the occupant’s head.
In a rollover, SRS curtain airbags on both sides of the vehicle deploy between the occupant and the side window and supplement the seatbelt by reducing the impact to the occupant’s head.
In an offset frontal collision, SRS curtain airbags on both sides of the vehicle deploy between the occupant and the side window and supplement the seatbelt by reducing the impact to the occupant’s head and chest.
SRS side airbag
T..
Operation
The SRS side airbag and SRS curtain
airbag can function only when the ignition
switch is in the “ON” position.
The following airbags deploy independently
of each other since each has its
own impact sensor...
Other information:
Subaru Forester 2019-2024 Owners Manual: Light control and wiper control levers/switches
..
Subaru Forester 2019-2024 Owners Manual: Operating the window
With one-touch auto up and down feature Automatically close* Close Open Automatically open* *: To stop the window halfway, operate the switch to the opposite side. Without one-touch auto up and down feature Close Open NOTE Avoid the following...
Categories
- Manuals Home
- Subaru Forester Owners Manual
- Subaru Forester Service Manual
- Illumination brightness control
- Unlock using PIN Code Access
- Changing a flat tire
- New on site
- Most important about car
Average vehicle speed
This display shows the average vehicle speed since the trip meter was last reset. Pressing the TRIP RESET switch toggles the display between the average vehicle speed corresponding to the A trip meter display and the average vehicle speed corresponding to the B trip meter display. When either of the trip meter displays is reset, the corresponding average vehicle speed value is also reset.
